talib library SAR function calculation results are inconsistent with retested K-line interface
Author: tt8604, Created: 2022-10-08 01:19:27, Updated:Please ask why the SAR function calculations in the TALIB library, with arguments for ((2,20) or ((0.02,0.2)), cannot match the K-line calculations of the retest system, as shown below.
Function parameters as shown above
K-line calculated SAR value at 8.04 at 20 hours on 31 January 2021
The same K line on the retest system K line graph with a SAR value of 7.84
- GetTicker: 429: {"msg":"Requests too frequent.","code":"50011"}
- Please instruct me, when the stop loss value of the design draw line is greater than the deviation value, the three yuan calculation draw line should be changed but it does not work, I don't know where the problem comes from?
- The Internet
- Questions about _N (Num, Precision)
- The question of the value of the holdings in the stock market versus the stock market
- How to get the wrong information in the log?
- Hedging contracts
- I need to evaluate the following indicators and make judgments, please tell me how to write a formula that can be used for strategic conditions.
- Please tell me how to calculate the highest price and the lowest price in the historical range. Thank you.
- How should the code on the switch to JavaScript be written on the ok analog disk?
- Please tell me how the table is decorated.
- My experience with quantification
- Can you please provide a tutorial on jsp automatic voting?
- The Mayan language strategy is to use OK exchange to make mistakes.
- How to calculate the re-test fee
- Permanent contracts and storage issues
- Please teach me a drawing classroom problem.
- Is there any monthly 20-30 Martin Hager idea to arrange with a red card?
- How to buy and sell at the highest point in a minute k line
- pine script variable value problem
Inventors quantify - small dreamsSeveral prerequisites are required for comparing indicators from two different computational sources (e.g. in a graph and computed by a program): 1, the K-line data of the calculation indicator must be perfectly consistent and may be affected by K-line cycles. 2, indicator parameters. 3, indicator algorithm. There are also several factors to compare: 1, whether the indicator values of the contrast are on the same BAR on the same time frame, whether the BAR cycle is the same, whether the contrast varieties, contracts, etc. are consistent. 2, the contrast BAR is whether the state is complete. This kind of question is often raised and you can search for past posts.